Switch And Led Check; Rotary Encoder Check; Rotary Select Check; Executing Internal Device Check Start - Korg EMX1 Service Manual

2. Set up the volume knob and switches as
[MASTER VOLUME] : MAX
[TUBE GAIN] : MIN
[AUDIO IN LEVEL] : MAX
[MIC/LINE] : LINE
[EFFECT] : REVERB
[SYNTH OSCILLATOR] : AUDIO IN + COMB
3. Insert the SmartMedia, which is supplied by Korg.
4. Press [ERASE] + [PATTERN] + [STANDBY] (POWER ON)

5. Executing Internal Device check start....

If the internal checking works correctly, it proceeds to the next steps
automatically.
If "3>L MIC[16]" is displayed and stops for a while, please switch the
MIC/LINE switch to

6-1 Switch and LED check

Once "#PANEL" is displayed, all LED checks start. If OK, press [16].
Press switches indicated in the LED. (Start: [AUDIO IN] ...... End:[16])
6-2. Rotary encoder check <#R.Enc>
If [RE ->>1>-> +000] is displayed, rotate the Dial knob 24 steps to the right.
If [RE ->>1>-> +024] is displayed, press [16].
If [RE <-<1<<- -000] is displayed, rotate Dial knob 24 steps to the right.
If [RE <-<1<<- +024] is displayed, press [16].
6-3. Rotary select check <#R.Sel>
If [BPM SYNC EFFECT] is displayed, rotate EFFECT knob one by one
clockwise.
(BPM SYNC --> SHORT DL --> ..... REVERB)
"MIC".
follows: