Whirlpool Thin Twin Installation Instructions Manual page 8

Recessed and closet
installation
instructions
Recessed installation
Product dhensfons Recessed and closet
hstaflat3on
Pnstructjrons
This washer/dryer may be installed in a
recessed area or closet.
The installation spacing is in inches and
is minimum allowable. Additional
spacing should be considered for ease
of installation, servicing and compliance
with local codes and ordinances.
If closet door is installed, the minimum
unobstructed air openings in top and
bottom ore required. Louvered doors
with equivalent air openings ore
acceptable. Closet installation must be
exhausted.
Other installations must use the minimum
dimensions indicated.
Most installation will require at least 5 inch
clearance behind the dryer for the dryer vent.
Location must be large enough to fully open dryer
door.
(Shown with legs extended 1 inch from
bottom of washer/dryer.)
washer
I
i; 1
j
I
4
f
tz
l.d
drain
outtet
27-112"
front view
side view
Minimum installation spacing
Note: If recessed Installation Is exhausted, all
spacing can be 0 inches.
Additional clearance for wall, door and floor
moldlng may be required.
Recessed, non-exhausted installation must use
only the rear exhaust position and Exhaust
Deflector Kit Part No. 694609 is required.
rear view
p!z!.+2,.,,fl,
Closet installation
WARNING - To reduce the risk of fire,
this appliance MUST BE EXHAUSTED
OUTDOORS.
1
f
i
27-518"
closet door
in.
in.
side view
f
32-l/8"
L
front view
Unobstructed air openings are minimum for closet
door. Louvered door wlth equivalent air openings
is acceptable.
closet
/ doory p-o".
L
48
tq.
in.
F
II
FL I
I
* Additional
space may
be needed
1 \I
for exhaust
elbow.
+I h-1'
side view
Closet lnstallatton must be exhausted outdoors.
Panel G