Reset To Defaults; Locating Connect Buttons On Redlink Accessories - Honeywell TH8320R1003 Vision Pro 8000 Product Data

4. Select Wireless Manager.
Wireless Manager

Reset To Defaults

5. Select Add Device. The screen displays "Press Connect
on New Accessories." The thermostat is now in listening
mode.
Add Device
Connected Devices
NOTE: Accessories must be at least 2 feet away from the
thermostat or EIM during the linking process.
6. Press and quickly release the CONNECT button on each
new RedLINK accessory.
NOTE: For locations of CONNECT buttons on
RedLINK accessories, see "Locating the Con-
nect Buttons on RedLINK Accessories" begin-
ning on page 15.
Press Connect on
New Accessories.
Fig. 42. Thermostat in listening mode.
MCR33980
Fig. 40.
MCR33981
Fig. 41.
MCR34058
7. After a short delay (up to 15 seconds), check thermostat
to confirm the connection of each RedLINK accessory.
Touch or to review the list.
 
8. Touch Done at the thermostat after all new RedLINK
accessories are connected.
Outdoor Sensor
has been added
NOTE: Thermostat displays a count-down timer while in
the listening mode. If it detects no activity for 15
minutes, it exits listening mode.
Locating the Connect Buttons on
RedLINK Accessories
Wireless Outdoor Sensor
1. Press and quickly release the CONNECT button on the
Wireless Outdoor Sensor. After a short delay (up to 15
seconds), the thermostat will display "Outdoor Sensor
has been added."
Fig. 44. Wireless outdoor sensor connect button.
Portable Comfort Control
1. Press CONNECT on the Portable Comfort Control dis-
play screen.
Fig. 45. Portable Comfort Control connect button.
2. Press DONE on the Portable Comfort Control when it
displays "Connected."
15
®
VISIONPRO 8000 WITH REDLINK™
MCR33972
Fig. 43.
CONNECT
WIRELESS SETUP
MCR32942
68-0312—01