BT BT1100 Quick Setup And User Manual page 5

2 Activate the batteries and
follow the Set-up wizard
1. Activate the batteries by pulling
the plastic tab away from the
back of the handset.
2. The handset will check for a
link with the base station.
Once found, the screen will
show, Please set the time
and date. Press the Left option
button on the handset to
follow the setup wizard. You'll
need to set the time and date, but you can then
press the Right option button
further options until setup is complete (you can
always set these up later).
If you need some help, call us on 0800 218 2182* or go to bt.com/producthelp
Rechargeable batteries
already fitted
Remove this tab
and charge batteries
for 24 hours before use.
Please set the
time and date
to skip any
Quick set-up guide Quick set-up guide
Talk/Standby time
Under ideal conditions, the
handset batteries should give
up to 12 hours talk time or
120 hours standby on a single
charge.
Please note that new Ni-MH
rechargeable batteries don't
reach full capacity until
they've been in normal use
for several days.
Battery low warning
The icon will flash, you'll
see the message Battery Low in
the display and hear a warning
beep every minute, to indicate
that you need to recharge your
handset before you can use it.
You can remove the display
message by selecting Hide. If
the battery charge completely
runs out, the display will show
Batteries flat. Please charge.
You must recharge the handset
batteries before you can use
the handset. If the charge
completely runs out the
handset will switch off. Place
the handset on the base or
charger to charge.
5 5