4 Use your TV
Switching on your TV and putting it in
Standby mode
Remote Control
Remote Control
To Turn the TV On from Standby or Off to Standby
•
Press
on the Front panel or the Remote Control.
Note(s)
• Energy consumption contributes to air and water pollution. When the AC Power cord
is plugged in, your TV consumes energy with a very low Standby Power consumption.
Adjusting volume
Remote Control
To decrease or increase volume
•
Press VOL
/
on the Front panel or press VOL + /
Remote Control.
VOL
: Volume Down
VOL
: Volume Up
To mute or unmute sound
•
Press
on the Remote Control to mute the sound.
again or VOL + /
•
Press
TV
TV
on the
to recover the original sound.
Switching channels
Remote Control
To select Channels by using CH
Press CH
(Up) on the Front panel or press CH + /
•
(Down) /
on the Remote Control.
To select Channels by using the NUMBER keys
Digital TV operation
•
For Digital channels, press a number followed by a dot "•" and the
corresponding sub channel number.
–
When selecting Digital channel 11.1
Be sure to press • before entering the subchannel number.
Analog/Cable TV operation
–
When selecting cable or Analog channel 11
Press PREV.CH to return to the previously viewed channel.
Note(s)
• To select the non-memorized channels, use the NUMBER keys.
• No Signal will appear on the TV screen after the subchannel broadcast is over.
• Audio only program message will appear on the TV screen, when you receive only a
sound signal.
16
TV
/
or CH + /
Continued on next page.
English