Page 1
www.telephones.att.com User’s manual Part 2 SB67128 DECT 6.0 Repeater This manual contains information about this product’s installation and operation. Please also read Part 1 - Important product information. For customer service or product information, visit our website at www.telephones.att.com or call 1 (888) 915-2007.
Before you install Parts list • �B6��2� DECT 6.0 repeater • Power adapter • Part � Important product information • Part 2 User’s manual • Package of screws Use only the power adapter supplied with this product. To obtain a replacement, visit our website at 1 (888) 915-2007.
Page 3
About the repeater You can use a repeater to extend the operating range for the AT&T �B6���� DECT 6.0 4-line corded/cordless telephone system to cover areas where the signal is very weak or not available. The repeater extends the range in all directions, even going around certain barriers. The telephone base, cordless handsets and repeaters are linked through wireless connections.
Page 4
Registration You should register your repeaters to the telephone base before choosing locations for them in the building. NOTE: You can register a repeater to an �B6���� telephone base without deregistering it from a previous telephone base. New registrations overwrite any previous repeater registrations.
Page 5
Registration STATUS indicator light Slow flash The repeater is powered on and in idle mode waiting to be re- registered. -OR- The registered repeater is not connected to the telephone base. -OR- Your telephone base has no power. Quick flash The repeater is registering to the telephone base.
Installation After you have plugged in your repeaters in the locations you think are best, place a call from a cordless handset (AT&T �B6��0�) and while talking, move around the building to test the reception. You may want to adjust the position of repeaters to receive the best reception. Plug the small end of the power adapter into the power jack on the front of the repeater and route the cord through the slot on the bottom of the repeater.
Page 7
Installation You can place the repeater on a tabletop. You can install your repeater on a wall or other object with the provided screws. Please use the recommended placement and installation tips as follows: • The antennas needs to be in a high location (not on the floor or under a desk) for reception.
Page 8
Installation If you want to install your repeater on a wall or other object, use the provided screws. Professional assistance may be required to install screws on the wall. Then plug the large end of the power adapter into a nearby electrical wall outlet and raise the antennas. �crew holes NOTE: The power adapter is intended to be correctly oriented in a vertical or floor...
Troubleshooting If you have difficulty operating this repeater, try the suggestions below. To contact Customer �ervice, purchase accessories or obtain replacement parts, visit our website at 1 (888) 915-2007 or call Please retain your receipt as your proof of purchase. My repeater •...
Page 10
Troubleshooting My repeater cannot register to my telephone base. My repeater flashes slowly again after registration. I cannot deregister my repeater from the previous telephone base. Power failure recovery. • First try all the suggestions on the previous page. • Make sure your telephone base is model AT&T �B6����...
General product care To keep the repeater working and looking good, follow these guidelines: • Avoid putting it near appliances and devices that generate electrical noise (motors, fluorescent lights, etc.) • DO NOT expose it to direct sunlight or moisture. •...
Technical specifications RF frequency band Channels Operating temperature Repeater voltage (AC voltage, 60Hz) Repeater voltage (AC adapter output) Repeater operating range This repeater operates within the maximum power allowed by the Federal Communications Commission (FCC). Even so, this product can communicate over only a certain distance —...