Table of Contents
Advertisement
Maintenance
item No.
Checking solenoid operation
U033
Description
Applies current to each solenoid in order to check its ON status.
Purpose
To check the operation of each solenoid.
Method
1. Press the start key.
2. Select the solenoid to be operated.
3. Press the start key. The solenoid turns on for 1 s.
Display
BRANCH1
BRANCH2
MOTOR ON
*Solenoid of machine.
To stop motor driving, press [MOTOR ON] again.
Completion
Press the stop key. The screen for selecting a maintenance item No. is displayed.
Setting the limit for the ejection section of the built-in finisher
U236
Description
If the machine is equipped with an built-in finisher, this mode sets whether A5R/B5R/statement size paper is
output to the machine eject tray or not.
Purpose
If the machine is equipped with an built-in finisher and if paper jams occur due to curling of paper in the built-
in ejection section when two-sided copying onto A5R/B5R/statement size paper is performed, this mode is
used to change the setting to ON to disable ejection to the machine eject tray.
Setting
1. Press the start key.
2. Select ON or OFF.
Display
ON
OFF
Initial setting: OFF
3. Press the start key. The setting is set.
Completion
Press the stop key. The screen for selecting a maintenance item No. is displayed.
Y108690-3
Description
Solenoids
Feedshift solenoid (FSSOL)*
Feedshift solenoid (FSSOL)
The main motor (MM) and the paper feed motor (PFM) are
turned on.
Description
Does not eject to the machine eject tray.
Eject to the machine eject tray.
Service Manual
3LB
1-3-3
Advertisement
Table of Contents
