Battery Warning - Jensen CD-60W User Manual

This CD player operates on two 1.5V DC "AA" size (UM-3) alkaline batteries (Not
Included) or AC-DC adaptor with an output of 4.5V DC 700mA (Not Included).
BATTERY OPERATION
1. Open the battery compartment cover located on bottom of cabinet.
2. Insert two 1.5V DC "AA" size (UM-3) alkaline batteries (Not included) into the Battery
compartment following the polarity markings as indicated in the compartment.
3. Close the battery door.
NOTE : Disconnect AC adapter before install batteries.
For best performance and longer operating time, we recommend the use of alkaline
batteries.

BATTERY WARNING

1. Be sure that the batteries are installed correctly. Wrong polarity may damage the unit.
2. Use only the size and type of batteries specified.
1. Do not mix old and new batteries.
2. Do not mix alkaline, standard (carbon-zinc) or rechargeable (nickel-cadmium)
batteries.
3. If the unit is not to be used for an extended period of time, remove the batteries. Old or
leaking batteries can cause damage to the unit and may void the warranty.
4. Do not try to recharge batteries not intended to be recharged; they can overheat and
rupture. (Follow battery manufacturer's directions).
5. Do not dispose of batteries in fire, batteries may leak or explode.
6. Battery shall not be exposed to excessive heat such as sunshine, fire or the like.
AC ADAPTOR OPERATION
1. Before connecting the adaptor to the player, make sure that the AC voltage of the
adaptor corresponds to you local AC outlet voltage. The polarity of the adaptor must
match to the polarity markings next to the DC jack on the player.
2. If you are using a universal adaptor with an output polarity switch or polarized plugs,
be sure to set the polarity of the center plug to "+".
3. Plug the 4.5V DC 700mA AC-DC adaptor into an AC outlet.
4. Insert the DC plug into the DC IN jack on the player.
POWER SOURCE
E-4