Water Supply - Kärcher K 4.700 Original Instructions Manual

Check the secure connection by pulling
on the high-pressure hose.

Water supply

Warning
According to the applicable regula-
tions, the appliance must never be
used on the drinking water supply
without a system separator. Use a
suitable system separator manufactured by
KÄRCHER; or, as an alternative, a system
separator as per EN 12729 Type BA. Water
flowing through a system separator is consid-
ered non-drinkable.
Note: Impurities in the water can damage the
high-pressure pump and accessories. For
protection, the use of the KÄRCHER water fil-
ter (optional accessory, order no. 4.730-059)
is recommended.
Water supply from mains
Observe regulations of water supplier.
For connection values, see type plate/techni-
cal data.
Use a fibre-reinforced water hose (not in-
Î
cluded) with a standard coupling. (Mini-
mum diameter 1/2 inch (13 mm),
minimum length 7.5 m).
Illustration
Î
Screw the coupling element (supplied) to
the water connection on the appliance.
Push the water supply hose onto the cou-
pling unit, then connect it to the water sup-
ply.
Drawing in water from open reservoirs
This high-pressure cleaner is suited to work
with the KÄRCHER suction hose with back-
flow valve (Optional accessory, order no.
4.440-238) to draw in surface water, e.g. from
water butts or ponds (see specifications for
max. suction height).
Fill the KÄRCHER suction hose with
Î
backflow valve with water, screw to water
supply and hang into the water butt.
Appliance ventilation: Switch the appli-
Î
ance on with the high-pressure hose de-
tached and operate (max. 2 minutes) until
the water exits the high-pressure connec-
tion without bubbles. Switch off appliance
and reconnect high-pressure hose.

Caution
Dry runs lasting longer than two minutes lead
to damages to the high pressure pump. If the
appliance does not build up pressure within
two minutes, switch it off and proceed as in-
structed in the Chapter "Troubleshooting".
Illustration
Î
Push the spray lance into the trigger gun
and fasten it by turning it through 90°.
Illustration
Î
Unwind the high pressure hose from the
hose drum. Hold on to the transport han-
dle during this procedure.
Note: If the hand crank is in its secured
position, fold it up first.
Completely open the water tap.
Î
Insert the mains plug into the socket.
Î
Turn on the appliance "I/ON".
Î
Operation
Danger
The trigger gun is subjected to a recoil force
when the water jet is discharged. Make sure
that you have a firm footing and are also hold-
ing the trigger gun and spray lance firmly.
Caution
Prior to cleaning, make sure that the high
pressure is placed safely on level ground.
Wear protective goggles and protective cloth-
ing during the cleaning process.
Unlock the lever on the trigger gun.
Î
Pull on the lever of the trigger gun; the de-
Î
vice will switch on.
Note: Release the lever of the trigger gun; the
device will switch off again. High pressure re-
mains in the system.
Spray lance with pressure regulation
Carrying out the most common cleaning
tasks. The work pressure can be stagelessly
regulated between "Min" and "Max".
Release the lever on the trigger gun.
Î
Turn the spray lance to the desired posi-
Î
tion.
Note: Suitable for working with detergent; for
this, turn the spray lance to the "Mix" position.
- 5
(1
Start up