Panasonic SJ-MJ55GH Service Manual page 14

1. Set the battery and connect the remote controller. (The position of
the HOLD switch of remote controller is "OFF".)
2. Turn off the power, and switch main unit's HOLD switch off.
3. Press the VOL+( ), VOL-( ),
remote controller within two seconds. (asshown in
4. When the adjustment mode is activated, "T0E " will be displayed
on the LCD of remote controller. After "T0E " is displayed, select
the desired adjustment item with the
the remote controller. (If it is not displayed, perform the
procedures written above again.)
*In the display of T0E ~ TFE shown above, you must adjust T0E , T1E , T2E and T3E . You must
perform the adjustment by observing the order T0E
Note:
If it is going to perform "T2E" and "T3E", without performing "T1E", it will be displayed as "NG".
If it is going to perform "T3E" when "T2E" is "NG", it will be displayed as "NG".
( ), and
Fig. 5
button or
T1E T2E
( )keys on the
Fig. 5 )
button of
T3E .