Installation Manual - Sharp SF-2314 Service Manual

5. Optional paper feed unit (SF-CM14),

Installation Manual

For use with compatible SHARP copies.
See SHARP copier Installation Manual to determine suitability.
Included parts
Mounting screw A,
1 pc
[SF-2414/2514 only]
(1) Set the main copier unit on the paper feed unit.
1 Lift the main copier unit by the grips, place it upon the paper feed
unit, and slip the positioning holes (3 locations) on the bottom of
the main copier unit over the 3 positioning pins on the paper feed
unit.
[NOTE] This procedure should always be performed by two
people.
Grip
Positioning pin
Mounting screw B,
2 pc
Grip
Positioning pin
(2) Remove the paper tray from the main copier
unit.
1 While lifting up slightly, gently pull out on the paper tray until it
stops.
2 Then, lift up on the paper tray with both hands and remove it.
(3) Open the upper unit of the main copier unit.
1 Press the release buttons on the left and right sides of the main
copier unit's front cover, then open the front cover.
2 Push the upper half release lever (green) to the right and down,
then gently open the upper unit.
Front cover release buttons
4 – 7
Front cover
Upper half
release lever