Table of Contents
Advertisement
ASSEMBLY
Caution:
Forcing in MIDDLe STeM with CAM
LOCK raised may form a burr on
camlock. If this happens, remove
burr with knife to allow insertion.
Assembly is easy and
requires no tools.
Position S-rod upright.
1
rotate
the
2
COLLAr fully in
the
counterclockwise
direction.
Insert your finger
3
inside the tube and
make sure the INTerNAL CAM LOCK is flush with the
inside of the tube.
Insert the MIDDLe STeM into the S-rOD,
4
with the SILver BUTTON pointed upward
rotate the MIDDLe STeM until the SILver BUTTON
5
locates in the hole.
Twist the LOCKING COLLAr fully in the clockwise direction
6
until it locks.
repeat this process on the LOWer STeM.
7
Using the BOLT and KNUrLeD KNOB, attach the
8
SeArCHCOIL to the LOWer STeM.
Adjust the LOWer STeM to a length that lets you maintain a
9
comfortable upright posture, with your arm relaxed at your side,
and the SeArCHCOIL parallel to the ground in front of you.
Wind the CABLe securely around the STeMS, leaving slack at
10
the bottom.
Connect CABLe PLUG to housing.
11
Do not twist the Cable or Plug. Turn Locking ring only. Use
minimal finger pressure to start the threads. Do not cross-
thread. When the Locking ring is fully engaged over the
threaded connector, give it a firm turn to make sure that it is
very tight. When the Locking ring is fully engaged over the
threaded connector, it may not cover all of the threads.
Tighten both LOCKING COLLArS.
12
*
Note: very tall users can purchase the optional extended
Lower Stem (TUBe5X), for extended reach.
LOCKING
S-ROD
S-ROD
5
LOCKING
COLLAR
S-ROD
MIDDLE STEM
MIDDLE STEM
4
2
3
INTERNAL
CAM LOCK
SILVER BUTTON
4
MIDDLE
STEM
7
Advertisement
Table of Contents
