Lamp Replacement Counter - Sanyo PLV-Z4000 Service Manual

Lamp Replacement

Lamp replacement counter

Be sure to reset the lamp replacement counter after the lamp is replaced. When the lamp replacement counter is reset, the LAMP
REPLACE indicator stops lighting.
1
Turn the projector on and press the MENU button to display the
On-Screen Menu. Select the Setting Menu with the Point
buttons. Press the Point
items.
2
Select Lamp counter reset and then press the OK or Point
buttons. "Lamp replacement counter reset?" appears. Select [Yes]
and then press the OK button.
3
Another confirmation dialog box appears, and select [Yes] to
reset the Lamp replacement counter.
✔
Note:
• Do not reset the Lamp replacement counter without implementing lamp
replacement. Be sure to reset the Lamp replacement counter only after
replacing the lamp.
This projector uses a high-pressure lamp which must be handled carefully and properly. Improper handling may result in
accidents, injury, or create a fire hazard.
● Lamp lifetime may differ from lamp to lamp and according to the environment of use. There is no guarantee of the same
lifetime for each lamp. Some lamps may fail or terminate their lifetime in a shorter period of time than other similar lamps.
● If the projector indicates that the lamp should be replaced, i.e., if the LAMP REPLACE indicator lights up, replace the lamp
with a new one IMMEDIATELY after the projector has cooled down.
(Follow carefully the instructions in the Lamp Replacement section of this manual.) Continuous use of the lamp with the
LAMP REPLACE indicator lighted may increase the risk of lamp explosion.
● A Lamp may explode as a result of vibration, shock or degradation as a result of hours of use as its lifetime draws to an end.
Risk of explosion may differ according to the environment or conditions in which the projector and lamp are being used.
IF A LAMP eXPLodeS, tHe FoLLoWING SAFetY PrecAutIoNS SHouLd Be tAKeN.
If a lamp explodes, disconnect the projector's AC plug from the AC outlet immediately. Contact an authorized service station
for a checkup of the unit and replacement of the lamp. Additionally, check carefully to ensure that there are no broken shards
or pieces of glass around the projector or coming out from the cooling air circulation holes. Any broken shards found should
be cleaned up carefully. No one should check the inside of the projector except those who are authorized trained technicians
and who are familiar with projector service. Inappropriate attempts to service the unit by anyone, especially those who are
not appropriately trained to do so, may result in an accident or injury caused by pieces of broken glass.
or OK buttons to access the submenu
8
LAMP HANdLING PrecAutIoNS
Lamp counter reset
ed
8
- 14 -
Select Lamp counter reset
and press the OK or Point
8
buttons. "Lamp replacement
counter reset?" appears.
Select [Yes] and press
the OK button, then
another confirmation
box appears.
Select [Yes] again to reset
the lamp counter.