Dispenser Removal; Display Pcb; Ice Button Assembly - LG LSXS26466 Series Service Manual

How to disassemble and assemble
3-10 DISPENSER
1) Pull out the drain
3) If nozzle is interfered with button, push and pull out the
bottom of button and then pull out the right side.
4) Holding the inner side of
the dispenser pull
forward to remove.
CAUTION: When replacing the dispenser cover make
sure the lead wire does NOT come off and the water line
is not pinched by the dispenser.

3-11 DISPLAY PCB

As shown below, remove 1 screw on the PCB fixing screw.
Remove the display PCB fixing screw.
Case, PCB Case, PCB
2) Use these 2 holes to pull
out the bottom
5) Remove the
lead wire.
Figure 28
Display PCB Display PCB

3-12 ICE BUTTON ASSEMBLY

1) Remove the 1 screw holding the lever.
2) Remove the spring from the hook.
3) Push and pull on the tab to remove.
Button Lever
3-13 WATER BUTTON ASSMEBLY
1) Remove screws.
2) Grasp the Button assembly and lift.
Button Lever