Hitachi DZ-GX3300E Service Manual page 40

Troubleshooting > Messages and Troubleshooting
Message
Disc error has occurred.
Unfi nalize is not completed.
Disc error has occurred.
Disc full.
Cannot execute.
Disc has no data.
Disc has no Play List.
Disc includes protected
scenes.
Delete scenes?
YES NO
Disc is full.
Cannot add control info.
Cause/condition for
message to appear
Appears when a recorded fi le cannot
be read or written. If no recovery is
made even when the disc is cleaned
or unfi nalized again, the disc may be
defective.
Appears when an accident, such as
power off, occurred during unfi nalizing.
If no recovery is made even when the
disc is cleaned or unfi nalized again, the
disc may be defective.
Also appears when reading or writing
from/to recorded fi le cannot be performed
be cause the disc is dirty.
Appears when the disc has been edited
on a device other than the DVD video
camera/recorder, and mismatch has
occurred in recorded data.
Appears if the recording capacity of disc
has reached the limit during editing of
video fi le.
Appears when playback or editing is
attempted using the Disc Navigation
function with no scene recorded on disc.
Appears if switching of play list is
selected with no play list registered.
Appears if the loaded disc has a program
(scene) that is write-protected by the
software write-protect function, which is
effective in program units. Although the
DVD video camera/recorder is equipped
with a software disc-protect function
that is effective for disc units, it does not
comply with software write-protect for
program units. (The DVD Forum defi nes
two types of software protect for DVD-
RAM: disc units and program units.)
Appears when the card contains a scene
write-protected by a device other than
this DVD video camera/recorder.
Appears if the number of scenes on play
list exceeds the upper limit (999) while
control information is being added.
[Refer to *1 page 4-2]
4 - 7
Troubleshooting
Clean the disc, referring to "4-3-5
Cleaning disc and optical pickup", or
replace it.
Set the power switch to "OFF",
reattach the AC adapter/charger,
set the power switch to "Movie", and
then unfi nalize the disc again. Or,
press the DISC EJECT button to
remove the disc, reload it, and then
unfi nalize it again.
Replace the disc.
Refer to "4-3-5 Cleaning disc and
optical pickup" and clean the disc.
Or replace the disc.
Format the disc (deleting all recorded
data), or replace the disc.
Delete unnecessary scenes, or replace
the disc.
Operate the DVD video camera/
recorder after the message
disappears.
Operate the DVD video camera/
recorder after the message
disappears.
Release the write-protect using the
device that has the software write-
protect function for program units,
or choose "YES" and designate it to
delete the scenes.
Release the write-protect using the
device which set it. Or choose "YES"
and delete the scene.
Delete any unnecessary scenes, or
combine several scenes, and then
operate the DVD video camera/
recorder.