Hitachi DZ-GX3300E Service Manual page 36

Troubleshooting > Messages and Troubleshooting
Message
Cannot execute.
Unselect multiple scenes.
Cannot read disc.
Check dirt/crack/bothside
contrary/inserted correctly.
CANNOT RECORD
PHOTOS.
Cannot replace thumbnail
on PHOTO scenes.
Cannot select any more
scenes
CARD ALMOST FULL
Card error has occurred.
Format the card now?
Card error.
Card error has occurred.
Formatting is not complete.
Card error has occurred.
Keep card inside & restart.
Card full.
Cause/condition for
message to appear
Appears if an attempt is made to
select multiple scenes for division: The
specifi cations state that dividing
multiple scenes is impossible.
Appears when reading or writing any
recorded fi les cannot be done due to dirt
on disc.
Appears when a warped or distorted
disc,
or a logically damaged disc, whose
initialization was previously interrupted,
is loaded.
Appears if an attempt is made to record
stills on DVD-RW/DVD-R/+RW: The
specifi cations state that no still is
recordable on DVD-RW/DVD-R/+RW.
Appears when a photo thumbnail was
selected for change in scene editing
menu: The specifi cations stipulate that
the thumbnail of still cannot be changed.
Appears when the number of scenes
selected on card has exceeded the upper
limit of 999 scenes.
Appears when the remaining number of
recordable stills has reached less than
10 during recording.
Appears when a card initialized on PC,
etc., or a card whose initialization was
interrupted before, is loaded.
Appears when the card cannot be
recognized because its terminals are
dirty.
Also appears when data other than
photos is recorded on card.
Appears when a damaged card is
initialized.
Appears when an error occurred during
editing of movie fi les.
Appears when the recording capacity of
card has reached the limit during
recording.
Appears when a card whose remaining
recording capacity is small, and on
which no still can be recorded, is loaded.
Appears when the remaining capacity of
card has reached the recordable limit.
4 - 3
Troubleshooting
Divide scenes one by one.
Refer to "4-3-5 Cleaning disc and
optical pickup" and clean the disc.
Or replace the disc.
Replace the disc.
Use a DVD-RAM or card when
recording photos.
Select a movie to change the
thumbnail.
Release the selection of unnecessary
scenes.
Prepare another card, or delete
unnecessary stills.
Choose "YES" and designate it to
initialize the card (deleting all
recorded data).
Use a dry cloth to clean the card
terminals.
Replace the card.
Replace the card.
Set the power switch to " OFF", and
after several seconds, set it to "Card
Still".
Replace the card, or delete
unnecessary stills.
Replace the card, or delete
unnecessary stills.
Replace the card, or delete
unnecessary stills.