Main Burner Ignition & Usage; Methods Of Burner Ignition; Main Burner Ignition; To Extinguish Burner - Weber Spirit E-310 Owner's Manual

METHODS OF BURNER
IGNITION
There are two ways to ignite
burner 1. The first is by using
the electronic Crossover
ignition system built into your
grill. The second is with a
match.
Next are the steps for igniting
your grill using the electronic
Crossover ignition system.
®
On the following page are
steps for igniting your grill
with a match.
Summary lighting instructions are inside the
cabinet door.
Some batteries have a plastic
protective wrap around them.
This plastic must be removed
before you attempt to ignite
your grill. Do not confuse this
plastic with the battery label.
18
WWW.WEBER.COM
®
MAIN BURNER IGNITION & USAGE

MAIN BURNER IGNITION

Electronic Crossover
The electronic Crossover
1 with a spark from the igniter electrode inside the Gas
Catcher™ ignition chamber. You generate the energy for
the spark by pushing the igniter button. You will hear the
igniter clicking. Burner(s) 2 (and 3) can be lit after burner
1 is lit.
®
A) Open the grill lid (1).
Failure to open the lid before igniting the
grill's burners, or not waiting five minutes
to allow the gas to clear if the grill does
not light, may result in an explosive flare-
up which can cause serious bodily injury
or death.
B) Make sure ALL burner control knobs are turned
off (2). Check by pushing control knobs in and turning
them clockwise until they stop.
m WARNING: The burner control knobs
must be in the off ( ) position before you
turn on the LP tank valve. If they are not
in the off ( ) position when you turn on
the LP tank valve, the "excess gas flow
control" feature will activate, limiting
the flow of gas from the LP tank. If this
should occur, turn off the LP tank valve
and burner control knobs. Start over.
When the "excess gas flow control" feature
is activated, a small amount of gas is still
flowing to the burners. After turning off the
LP tank valve and burner control knobs,
wait at least five minutes for the gas to clear
before attempting to light the grill. Failure
to do so may result in an explosive flare-up,
which can cause serious bodily injury or
death.
C) Turn the LP tank on by slowly turning the tank valve
counterclockwise; wait 60 seconds (3).
D) Push burner 1 control knob in and turn it
counterclockwise to start/high ( ) position (4).
IMPORTANT: Always ignite burner 1 first. The other
burner(s) ignite from burner 1.
E) Push and hold in the igniter button (5). You will hear
the igniter clicking.
F) Check that burner 1 is lit by looking through the
cooking grates. You should see a flame.
m WARNING: While igniting the grill or
cooking, never lean over open grill.
m WARNING: If burner 1 fails to ignite
within five seconds, stop, turn the burner
control knob to off and wait five minutes
to allow the gas to clear before you try
again or light with a match.
G) After burner 1 is lit, you can turn on burner 2 (and
burner 3).

TO EXTINGUISH BURNER

Push each burner control knob in and turn it clockwise to
the off ( ) position. Turn gas supply off at the source.
Ignition System
®
ignition system ignites burner
®
m DANGER
m DANGER
1
2
3
4
5