Troubleshooting With Error Code - LG WT1201C Series Service Manual

4-6. TROUBLESHOOTING WITH ERROR CODE

ERROR DECISION
ERROR
· WATER LEVEL
WATER
SUPPLY dose not rise to
the set level in within
30 minutes.
· Water is not
DRAINAGE
completely drained
within 12 minutes.
· Laundry
UNBALANCE
unbalance during
spin.
· LID is opened in
LID
OPEN the course of
intermittent spin,
normal spin or
processing
reservation.
BASIS
· Water faucet is closed?
· Water supply is interrupted.
· Inlet valve is clogged with
· Connector has bad contact
NO INLET
lamp blinks
· RED 6-pin connector has
· Is the drain hose located
· Drain hose is folded or
· Defective drain pump or the
· Laundry in the INNER TUB
· Washer is tilted.
· Lid is opened during
· Lid is opened while
· Check the connections to the lid
CAUSE FOR ERROR
OCCURRENCE
dirts.
to the inlet valve.
a bad connection at the main
board.
properly?
clogged due to freeze or dirt.
WHITE 6-pin connector to the
main board has a bad
connection.
is filled unevenly.
intermittent spin or normal
spin?
processing reservation?
switch and at the WHITE 6-pin
connector at the main board.
31
REMEDY
· Open water faucet.
Wait until water supply is
resumed.
· Clean or replace filter.
· Correct the connector
contact.
· Same as above.
· Drain hose properly positioned
at 0.9 ~ 1.2 m (36 ~ 48 inches)
above the floor.
· Make sure the drain hose is not
plugged with a foreign object.
· Check drain pump motor
contact. Replace the pump if
necessary.
· Load the washer as evenly as
possible.
· Adjust the leg.
· Close the lid.
· Close the lid.
· Check the connections.
· If the connection is good, check
the lead wire and replace it if
necessary.