Advertisement
Open the back panel of the Camera and remove the battery compartment
cover. Install four (4) C size alkaline batteries with polarities as indicated in
the Battery Compartment. Re-install the Battery Compartment Cover.
Thread the provided Mounting Strap through the Eyelets on the back of the
camera and secure to a tree or pole approximately 36" from the ground as
shown.
Turn Camera on by sliding ON/OFF switch to the ON position.
Rotate the FUNCTION SWITCH to DATE and set the date by pressing the
ENTER button and UP/DOWN buttons to adjust selected field. Rotate the
FUNCTION SWITCH to TIME and set the date by pressing the ENTER
button and UP/DOWN buttons to adjust selected field.
Rotate the FUNCTION SWITCH to AUTO. Your Camera will now
automatically take pictures whenever an animal is detected in range -based
on the default settings below
Function
Photo Quality
Photo Delay after each photo is taken
Multi Shot Count
Setting
High
1 minute
1-Shot
FUNCTION SWITCH DETAILS
AUTO MODE
The camera's LCD screen will display the number of photos taken follow by the
pictures remaining when the FUNCTION SWITCH is set to AUTO. This is the
camera's normal state for taking pictures. During this mode, the camera will
sleep and use a minimal amount of battery life. When the PIR motion sensor
detects an animal, it will wake up the camera and immediately take a picture.
When in AUTO MODE, press the ENTER button and the camera will
immediately take a picture.
DATE
The camera's current date setting will be displayed by the LCD when the
FUNCTION SWITCH is set to DATE. Press the ENTER button and the Month
digits of the date will flash. Use the UP and DOWN buttons to adjust the
Month. Press the ENTER button to advance to the Day digits and repeat the
process. Press the ENTER button to set Year. Press the ENTER button to
confirm the new settings.
TIME
The camera's current time setting will be displayed by the LCD when the
FUNCTION SWITCH is set to TIME. Press the ENTER button and the Hour
digits of the Time will flash. Use the UP and DOWN buttons to adjust the
hour. Press the ENTER button to advance to the Minute digits and repeat the
process. Press the ENTER button to set AM or PM. Press the ENTER button
again to confirm the new settings.
Pressing and holding the Up or Down Buttons will cause the digits to increase or
decrease at double speed.
MFH-DGS-L20
Advertisement
