Safety Belts - Chevrolet Spark 2016 User Manual

To return the rear seats to the
normal seating position:
1. Move the safety belt out of the
way by putting the safety belts
into the belt guide on the trim.
The safety belt should not
cross the seatback locking
mechanism when raising the
seatback.
2. Lift the seatback up slightly and
reinstall the head restraint. See
Head Restraint Removal and
Reinstallation under Lower
Anchors and Tethers for
Children (LATCH System) 0 74.
3. Push the seatback rearward all
the way to lock it in place.
4. Push and pull the top of the
seatback to be sure it is locked
into position.
5. Return the seat cushion to its
original position and push
down on the front part of the
seat cushion until it latches.
6. Remove the safety belt from
the belt guide on the trim.
7. Repeat Steps 1 6 for the other
seatback and seat cushion,
if necessary.
If added cargo space is not needed,
the seatbacks should be kept in the
upright, locked position
Seats and Restraints

Safety Belts

This section of the manual
describes how to use safety belts
properly. It also describes some
things not to do with safety belts.
Warning
Do not let anyone ride where a
safety belt cannot be worn
properly. In a crash, if you or your
passenger(s) are not wearing
safety belts, injuries can be much
worse than if you are wearing
safety belts. You can be seriously
injured or killed by hitting things
inside the vehicle harder or by
being ejected from the vehicle. In
addition, anyone who is not
buckled up can strike other
passengers in the vehicle.
It is extremely dangerous to ride
in a cargo area, inside or outside
of a vehicle. In a collision,
passengers riding in these areas
are more likely to be seriously
injured or killed. Do not allow
(Continued)
49