Advertisement
FCC INFORMATION
This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential instal-
lation. This equipment generates, uses and can radiate radio frequency energy
and, if not installed and used in accordance with the instructions may cause harm-
ful interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the inter-
ference by one or more of the following measures:
-- Reorient or relocate the receiving antenna.
-- Increase the separation between the equipment and receiver.
-- Connect the equipment into an outlet on a circuit different from that to which
the receiver is connected.
-- Consult the dealer or an experienced radio/TV technician for help.
FCC Warning - This equipment may generate or use radio frequency energy.
Changes or modification to this equipment may cause harmful interference unless
the modifications are expressly approved in the instruction manual. The user
could lose the authority to operate this equipment if an unauthorized change or
modification is made.
FCC Warning - Changes or modifications not expressly approved by the party
responsible for compliance could void the user's authority to operate the equip-
ment.
The serial number of this product may be found behind the lower operating
doors. No others have the same serial number as yours. You should record the
number and other vital information here and retain this book as a permanent
record of your purchase to aid identification in case of theft.
Date of Purchase
Dealer Purchased from
Dealer's Address
Dealer's Phone No.
Model No.
2
IM-3204
Resetting the Microprocessor
NOTE: Resetting the microprocessor will cause radio memory channels to be lost.
Should the system not operate properly, the internal microprocessor may require reset-
ting. To reset the microprocessor, use the point of a pen to press the reset button
through the access hole behind the right lower door. See "Illustration and Master Station
Controls" on pages 4 and 5.
11
Advertisement
