Before Using The Unit; Operation Procedure In Destination Selection Mode; To Return The Destination Setting To No-Set - Sony HDW-D2000 Operation Manual

Before Using the Unit

When turning on the POWER switch for the first time
or after executing maintenance menu item "M49:
RESET ALL SETUP", the unit enters the mode for
selecting a destination (J or SYL
Select a destination by following the operation
procedure in destination selection mode.
Once destination selection is executed, the unit does
not enter destination selection mode when the POWER
switch is turned on again, and the unit operates in
accordance with the destination selection.
For details about maintenance menu item M49, refer to the
Maintenance Manual.
Note
Be sure to select a destination before using the unit. If
no destination is selected, the unit cannot perform
playback and recording properly.
Operation Procedure in
Destination Selection Mode
1
Turn on the POWER switch.
The following display appears in the menu display
section of the control panel.
DESTINATION SEL – NO – SET
SELECT
F1 F2 F3
2
Press the F2 (SELECT) button.
• Pressing the F2 (SELECT) button blinks "NO-
SET".
• Pressing the F3 (-) or F4 (+) button selects the
destination "50 : SYL", "59.94 : SYL", or
"59.94 : J".
• Pressing the F1 (RETURN) button returns the
display to the original display shown in step 1.
DESTINATION SEL – NO – SET
–
RETURN
F1 F2 F3
The menu display changes as follows, depending
on the destination selected.
.........................................................................................................................................................................................................
1) J for Japan, and SYL for any destination other than Japan.
1)
).
SET
F4 F5 F6
+
SET
F4 F5 F6
• When "50 : SYL" is selected as destination
("50 : SYL" blinks)
DESTINATION SEL – 50 : SYL
–
RETURN
F1 F2 F3
• When "59.94 : SYL" is selected as destination
("59.94 : SYL" blinks)
DESTINATION SEL – 59.94 : SYL
–
RETURN
F1 F2 F3
• When "59.94 : J" is selected as destination
("59.94 : J" blinks)
DESTINATION SEL – 59.94 : J
–
RETURN
F1 F2 F3
3
Press the F5 (SET) button.
• Pressing the F5 (SET) button sets the destination
to the selected destination.
• When the message "TURN OFF/ON POWER!!"
appears after "Initializing!!" is displayed for
about five seconds, turn off the POWER switch.
Initializing!!
F1 F2 F3
TURN OFF/ON POWER!!
F1 F2 F3
To return the destination setting to "NO-
SET" (not selected)
Reset all the unit settings to the factory settings using
maintenance menu item "M49: RESET ALL SETUP".
For details about the maintenance menu, refer to Section 3
in the Maintenance Manual Volume 1.
Note
If you execute maintenance menu item M49, all the
settings including the setup menu settings are reset.
+
SET
F4 F5 F6
+
SET
F4 F5 F6
+
SET
F4 F5 F6
SET
F4 F5 F6
SET
F4 F5 F6
17