Kia quoris Manual page 134

Reprogramming a single
®
HomeLink button
To program a new device to a previ-
®
ously trained HomeLink
low these steps:
1. Press and hold the
®
HomeLink button. Do NOT release
until step 4 has been completed.
2. When the indicator light begins to
flash slowly (after 20 seconds),
position the handheld transmitter
1 to 3 inches away from the
®
HomeLink surface.
3. Press and hold the handheld
transmitter button.
®
HomeLink indicator light will
flash, first slowly and then rapidly.
4. When the indicator light begins to
flash rapidly, release both buttons.
5. Press and hold the just-trained
®
HomeLink button and observe
the red Status Indicator LED. If the
indicator light stays on constantly,
programming is complete and
your new device should activate.
Erasing HomeLink
Individual buttons cannot be erased.
However, to erase all three pro-
button, fol-
grammed buttons:
1. Press and hold the two outer
desired
HomeLink
cator light begins to flash-after 20
seconds.
2. Release both buttons. Do not hold
for longer than 30 seconds.
The Integrated HomeLink
Control System is now in the training
(learn) mode and can be pro-
grammed at any time following the
The
appropriate steps in the Programming
sections above.
®
buttons
®
buttons until the indi-
®
Wireless
FCC ID: NZLZTVHL3
IC: 4112A-ZTVHL3
This device complies with
Industry Canada Standard
RSS-210.
Operation is subject to the following
two conditions:
1. This device may not cause harm-
ful interference, and
2. This device must accept any inter-
ference received, including inter-
ference that may cause undesired
operation.
4
4-55