Kia quoris Manual page 133

Features of your vehicle
3. Return to the vehicle, firmly press
and hold for two seconds the desired
®
HomeLink button then release.
Repeat the "press/hold/release"
sequence a second time to com-
plete the programming. (Some
devices may require you to repeat
this sequence a third time to com-
plete the programming.)
4. Press and hold the just-trained
®
HomeLink button and observe
the red Status Indicator LED. If the
indicator light stays on constantly,
programming is complete and
your device should activate.
5. To program the remaining two
®
HomeLink buttons, follow either
steps 1 through 4 above for other
Rolling Code devices or steps 2
through 5 in
Programming for standard devices.
4-54
Gate operator &
Canadian programming
During programming, your handheld
transmitter may automatically stop
transmitting. Continue to press the
Integrated
Control System button (note steps 2
through 4
Programming portion of this docu-
ment) while you press and re-press
("cycle") your handheld transmitter
every two seconds until the frequen-
cy signal has been learned. The indi-
cator light will flash slowly and then
rapidly after several seconds upon
successful training.
Standard
®
HomeLink
Wireless
in the Standard
®
Operating HomeLink
To operate, simply press and release
the programmed HomeLink
Activation will now occur for the
trained device (i.e. garage door
opener, gate operator, security sys-
tem, entry door lock, home/office
lighting, etc.). For convenience, the
hand-held transmitter of the device
may also be used at any time.
®
button.