Mounting The Battery; Supplying Power From The Ac Adapter - Panasonic AG-DVX100A Operating Instructions Manual

Mounting the battery

1
Raise the viewfinder.
2
Push the battery straight in, and slide it
downward until it clicks into position.
3
Return the viewfinder to its original
position.

Supplying power from the AC adapter

1
Raise the viewfinder.
2
Push the battery-type connector on the
DC cable straight in, and slide it
downward until it clicks into position.
3
Connect the DC cable to the AC adapter.
4
Connect the AC cable to the power outlet.
5
Return the viewfinder to its original
position.
CAUTION:
This unit will operate on 110/120/220/240V
O
AC. An AC plug adapter may be required
for voltages other than 120V AC.
If a conversion plug is required, consult
with your dealer as to which one is to be
purchased.
The rating plate is on the underside of the
O
AC Adapter.
Disconnect the AC mains plug from the AC
O
22
Removing the battery
While pressing the battery eject button, slide
the battery upward to remove.
O Set the POWER switch to OFF, and check
that the CAMERA/VCR lamp has gone off
before removing the battery.
O Support the battery with your hand to
ensure that it will not drop.
Battery eject button
1
2
3
1
2
Connect the AC adapter correctly as
shown in the figure.
O The battery cannot be charged while
supplying power from the AC adapter to the
camera recorder.
4
3