Disassembly - Pioneer XV-DV515 Service Manual

1

7.1.12 DISASSEMBLY

Note: For performing the diagnosis shown below, the following jig cables for service are required:
• GGD1266 (×2)
• GGD1222
• GGD1160
1
Bonnet and Tray panel
1
Remove the bonnet by removing the seven screws.
2
Press the STANDBY/ON button to turn on the power.
3 Press the 0 OPEN/CLOSE button to open the tray.
4
Remove the tray panel.
5
Press the 0 OPEN/CLOSE button to close the tray.
6
Press the STANDBY/ON button to turn off the power.
4
3 Tray
5
3
Tray panel
How to open the Tray when the power cannot be on
Insert a screwdriver (small) into the slit located at the bottom of
the unit, and slide the projection of the drive gear in the Loading
Mecha. Assy in the direction of the arrow, as indicated in the
photo. If the Tray pops out a little, fully pull it out by a hand.
Tray open
Bottom View
Screwdriver (small)
Projection
Drive gear
Loading Mecha. Assy
1
2
5
2 6
Slit
Screwdriver (small)
2
3
2
Test disc set
1
Set the test disc.
2
Press the 0 OPEN/CLOSE button to close the tray.
(The test disc is clamped.)
3
Press the STANDBY/ON button to turn off the power.
4
Pull out the power cord from the outlet
Test disc
1
2
Tray
XV-DV515
3
4
2
3
4
A
B
C
D
E
F
117