Advertisement
FAULT:
SOLUTIONS: Insure JMP4 is removed
FAULT:
SOLUTIONS: Verify JMP2 is installed
FAULT:
SOLUTIONS: Remove JMP3 to install the differentiator
If you are still unable to solve your kit problems you may send your kit in for
repair. For instructions on how to return kits for repair please see the "Factory
Repair of Assembled Kits" section of our Ramsey Kit Warranty page on the
inside back cover of this manual. You may also contact our Technical Support
Department at :
Phone:
Email:
Address:
Wrong Frequency Range in Astable mode
Insure JMP5 is removed and no Control Voltage is applied
Unit will not start when S1 is pressed in Monostable Mode
Verify JMP4 is installed
Output signal matches the input square wave
(585) 924-4560
techsupport@ramseyelectronics.com
Ramsey Electronics, LLC
Attn. Hobby Kit Department
590 Fishers Station Drive
Victor, NY 14564
UT5A 25
Advertisement
