Travis Industries 564 HO Installation Instructions Manual page 2

Log Set Installation
1. Remove both accent lights from the brackets and place them on the firebox floor, as shown below.
2. Install the burner support bracket, as shown below.
NOTE: The notch in the bracket faces inward.
3. Install the intake restrictor as shown below. Use the screws pre-installed on the rear wall of the firebox. The
intake restrictor is located behind the accent lights, on the rear wall of the firebox. Set the intake restrictor to
the correct setting for the vent configuration; see the owner's manual for details.
Page 2 of 9
564 HO Ember-Fyre Burner and Log Set
Installation Instructions
17601655 — 11/14/12
(sku 96900116)
© Travis Industries, Inc.