Samsung SHS-3320 User Manual page 8

3. Installing the Mounting Plate
D
Left-handed Right-handed
4. Installing the Magnetic Sensor
Left Trigger
5. Connecting the cable
C
B
D
H2
Install the door side magnetic sensor.
It should be installed in right way of the door.
CAUTION: The gap of the magnet sensors
between the door side and the door-frame should
be within 3/4"(20mm). If the gap is to wide, pull out
Left Trigger
the door side magnetic sensor to adjust the gap
enough to detect.
3/4˝(20mm)
1. Connect the cable from the exterior unit to
2. After connecting the cable, push the cable

Smart
Door Lock
1. Detach the Interior Mounting Plate from
the interior unit.
2. According to the right or left handed door,
adjust the link, and attach the mounting
plate.
3. Fasten the interior mounting plate with
three TH+M5x40 (H2) 90% of the way.
4. Align the Exterior Unit with the Interior
Mounting Plate and then tighten the
screws.
5. Cover the rubber pad on the Interior
Mounting plate.
CAUTION: Do not over-tighten, and check
the movement of dead bolt by the mechani-
cal key.
the interior unit.
into the hole of the door.
SHS-3320/3321