Delta 28-206 Instruction Manual page 14

ATTACHING THE TABLE TO
THE SAW
1. Remove the band saw blade.
2. Align the two table studs (A) Fig. 19, in the bottom of
the table, with the two holes in the trunnion assemblies
(B). NOTE: MAKE SURE THE SLOT (C) FIG. 19, IN THE
TABLE IS FACING TOWARD THE FRONT OF THE
SAW.
3. Place a M13 flat washer onto the table stud and
thread the table knob onto the table stud.
4. Repeat this process for the remaining table stud.
ATTACHING BLADE TO THE
SAW
1. DISCONNECT MACHINE FROM POWER SOURCE.
2. NOTE: THE 14" BAND SAWS USE 93½" LENGTH
BLADES.
3. Remove the table pin (A) Fig. 20 from the table.
4. Open the two wheel guard doors (B) Fig. 20, and the
blade guard door (C).
5. Make sure the quick tension lever (D) Fig. 20, is
positioned to the left of the machine.
6. NOTE: CHECK BLADE TO BE SURE TEETH WILL
POINT DOWN TOWARD TABLE WHEN INSTALLED.
IF NOT, TURN BLADE INSIDE OUT. Slide the band saw
blade, (teeth facing out), through the slot (E) Fig. 20, in
the band saw table.
7. Place the blade around the two wheel assemblies
(A) Fig. 21.
8. Replace the table pin (A) Fig. 20.
9. Close the two wheel guard doors (B) Fig. 20, and the
blade guard door (C).
10. Move the quick tension lever (D) Fig. 20, to the right
position to put tension on the blade.
11. See the section "OPERATING CONTROLS AND
ADJUSTMENTS" to adjust blade tension and tracking.
TABLE INSERT
Place table insert (A) Fig. 22, in opening of table. NOTE:
A tab (B) is provided on insert that engages with notch
(C) in table opening.
C
A
B
B
E
A
B
C
A
C
14
Fig. 19
Fig. 20
Fig. 21
B
A
Fig. 22
A
B
D