AT&T 945 User Manual page 62

w w w w w w w w w w w w
w w w w w w w w
❖ ❖ ❖
❖ ❖
w w w w w w w w w w w w
w w w w w w w w
❖ ❖ ❖
❖ ❖
58
Make or Answer a Call
continued from page 57
Speakerphone
To make a call, press and release the desired LINE
button or K. The SPEAKER light goes on. Wait
for a dial tone, then dial the call. Press K to end
the call.
To answer a call, press K or press the LINE
button of the incoming call. Press K again to
end the call.
NOTE: If headset is programmed as the default mode
(see "Set Automatic Mode" on page 41), you must
press K to activate the speakerphone.
Headset
You can use this phone hands-free when you install any
industry standard two-band 2.5mm headset (purchased
separately). For best results use an AT&T two-band
2.5mm headset.
Make sure the headset is plugged into the headset jack.
You will hear a double-beep if you press h when
the headset is not plugged in.
NOTE: If headset is programmed as the default mode,
(see "Set Automatic Mode" on page 41) but the
headset is not plugged in, the phone will switch to
speakerphone.
To make a call, press and release h or press
the desired LINE button and then press h.
The HEADSET light goes on. Wait for a dial tone,
then dial the call. Press h to end the call.
To answer a call, press h. Press h
again to end the call.
NOTE: If speakerphone is programmed as the default
mode (See "Set Automatic Mode" on page 41), you
must press h to activate the headset.