Information Display - Precor C100i Service Manual

Procedure 3.3 - Information Display
Software version numbers are invaluable for tracking and identifying problems and staying aware
of changes to the operation and features of the product.
Procedure
The information display will access the following data;
• Odometer
• Hour Meter
• U-Boot Software
• U-Base Software
• Lower Base Software
• Metrics Board Software
• Stride Dial Software
• Serial Number
• Usage log
• Error Log
Procedure
1. Start pedaling the C100i using a vertical motion.
2. With the PRECOR banner scrolling, press the keys RESET,6,5, sequentially.
3. DIAGS-INFORMATION DISPLAY will scroll across the display.
S T
4. Use the ,
5. ODOMETER display. Press the OK key.
6. The horizontal distance will be displayed in miles or kilometers and the vertical
distance will be displayed in steps.
Note: The odometer data is stored in non-volatile memory on the upper PCA. If the upper PCA
is replaced the odometer data will be lost.
7. Press the CLEAR key to exit the odometer display.
8. HOUR METER display. Press the OK key.
9. The operating time of the unit will be displayed as 12345 HOURS. The operating time
is defined as total amount of time that the unit has operated in program modes. The
hour meter is also used to provide the "time stamp" for the error code log.
10. Press the CLEAR key to exit the hour meter display.
keys to move to the desired display shown in the list above.
C100i Adaptive Motion Trainer
Page 10