Cyclone Separator; Filters - Hoover SH40080 Owner's Manual

CyClOne separatOr

WARNING
! !
To reduce the risk of personal injury, unplug
vacuum before cleaning or servicing.
Do not use vacuum without dirt cup or filters
in place.
How to Clean
Remove dirt cup as described in Fig. 3.1.
3.3 Twist filter assembly counterclockwise. Remove assembly from dirt cup.
3.4 Gently tap on the inside of a trash receptacle to remove dust and dirt.
3.5 Dirt and debris can be cleaned from the filter assembly with dusting brush
or a towel or rag.
Replace the filter assembly on the dirt cup, and twist it clockwise to secure
into position.
Replace dirt cup.
IMPORTANT
The cyclone separator should not be submerged in water.

filters

rinsable filter
WARNING
! !
To reduce the risk of personal injury, unplug
vacuum before servicing.
Do not use vacuum without dirt cup or filters
in place. Allow filter to dry completely before
replacing.
when to Clean
It is recommended that the Rinsable filter be
checked and cleaned at least every 2 months or
more frequently with heavy use.
How to Clean
Remove dirt cup as described in Fig. 3.1.
3.6 Twist dirt cup lid counterclockwise and remove
Rinsable filter.
3.7 Grasp tab on filter and remove from filter
cartridge.
3.8 Gently tap the filter and filter cartridge on the
inside of a trash receptacle to remove dust and dirt.
3.9 Hold Rinsable filter under running water to
clean.
Allow to air dry for 24 hours before replacing.
Replace filter in dirt cup and twist lid clockwise until
secure.
Replace dirt cup.
3.3 3.4
3.5
3.6 3.7
3.8
3.9
IMPORTANT
Rinsable can be rinsed in warm water (max
40°C). Allow to air dry for 24 hours before
replacing. Do NOT use any detergents or
boiling water to wash filter.
what to buy: rinsable filter
When used and maintained properly, your
Rinsable Filter should not need replacement
within the warranty period. If desired, an additional
filter is available at Hoover.com or call 1-800-
944-9200. Ask for Hoover Part No. 440001975.
®
9
Actual model may vary from images shown.