Table of Contents
Advertisement
VLAN Tutorials
Verify that all devices can ping each other before proceeding
Login to T2 via telnet or hyper-terminal,
From CLI type the following commands:
Enable VLANs, configure VLAN modes
vlan enable
vlan mode local-mode port-based remote-mode disabled
system reboot
Remove DSL ports from the Eth2 port-based VLAN
vlan port-group delete eth2 peer-interface port(1-25)
Optional configuration on the cascaded switch
Configure cascaded switch exactly as the first switch. Connect Eth1 of the cascaded switch to Eth2 of the
first switch. Repeat for each cascaded switch.
Convert this tutorial to a real-world configuration
Note that in this tutorial, all packets are untagged outside of the T2. This allows for a very quick, simple
installation of multiple switches since every switch can have the exact same configuration.
Be sure to NOT add all DSL ports to Eth2. This ensures that cascaded packets can only egress on Eth1
Create a configuration script following the command syntax for each step of the tutorial
Motorola, Inc.
549453-001-00-a
Page 44 of 51
Advertisement
Table of Contents
