Operating The Radio; Radio On; Band Selection; Tuning - Mazda 2014 CX-5 Owner's Manual

Interior Features
Audio System
qOperating the Radio
Seek tuning buttons
Channel preset buttons

Radio ON

Press a band selector button (
turn the radio on.

Band selection

Successively pressing the band selector
button ( ) switches the bands as
follows: FM1→FM2→AM.
The selected mode will be indicated. If
FM stereo is being received, "ST" will be
displayed.
NOTE
If the FM broadcast signal becomes weak,
reception automatically changes from
STEREO to MONO for reduced noise, and the
"ST" indicator will go out.

Tuning

The radio has the following tuning
methods: Manual, Seek, Scan, Preset
channel, and Auto memory tuning. The
easiest way to tune stations is to set them
on preset channels.
NOTE
If the power supply is interrupted (fuse blows
or the battery is disconnected), the preset
channels will be erased.
5-28
Scan button
Band selector buttons
) to
Manual tuning/Audio control dial
Auto memory button
Manual tuning
Turning the manual tuning dial will
change the frequency higher or lower.
Seek tuning
Pressing the seek tuning button (
will cause the tuner to seek a higher or
lower frequency automatically.
NOTE
If you continue to press and hold the seek
tuning button ( ,
continue changing without stopping.
Scan tuning
Press the scan button (
automatically sample strong stations.
Scanning stops at each station for about 5
seconds. To hold a station, press the scan
button ( ) again during this interval.
Preset channel tuning
The 6 preset channels can be used to store
6 AM and 12 FM stations.
1. To set a channel first select AM, FM1,
or FM2. Tune to the desired station.
,
), the frequency will
) to
)