Fcc Part 15 Notice - AKG AS8 Operating Instructions Manual

R L C
EMOTE EVEL ONTROL
Pin Number Function
1 Channel 1 Wiper
2 Channel 2 Wiper
3 Channel 3 Wiper
4 Channel 4 Wiper
5 Channel 5 Wiper
6 Channel 6 Wiper
7 Channel 7 Wiper
8 Channel 8 Wiper
9 Channel 1-8 CCW Connection (common to all channels, +5V)
10 Channel 1-8 CW Connection (common to all channels, ground)
11 Main CW Connection (ground)
12 Main Wiper Connection
13 Main CCW Connection (+5V)
14 Not Used
15 Reset to Local Mode (see Operating Instructions)
RS-232 SERIAL PORT - Provides access to and control of some of the operational features of the AS8. The port is
compatible with the serial port of a PC, or other controllers with RS-232 type serial ports. For hardware interconnection
and software details, see Appendix 1, "Serial Port Hardware and Software".
EXPANSION IN/OUT - Allow multiple AS8s to be used together. If
more than one AS8 are used together, the first AS8 (i.e. the one with
Expansion In port used but not the Expansion Out port) should be
switched to the Master mode, while all other AS8s should be in the
Slave mode. The Expansion Out of the second AS8 is connected to the
Expansion In of the first AS8, using the supplied cable.
MASTER/SLAVE SWITCH - Sets the AS8 for use as a Master device
or a Slave device. AS8s used singly should be set for Master mode
operation.
PWR IN - Connects to the CH40 power supply to provide power for
the AS8.
FCC P 15 N
ART OTICE
This equipment has been tested and found to comply with the limits for a class B digital device, pursuant to Part 15 of the
FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio communications. If this equipment does cause
harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
P
INOUT
LECNET EXPANSION
IN/OUT PORTS
7