Fujitsu ASYA07LGC Service Instruction page 54

8-1. FUNCTION SETTING
8-1-1 INDOOR UNIT
Follow the instructions in the Local Setup Procedure, which is supplied with the remote control,
in accordance with the installed condition.
After the power is turned on, perform the Function Setting on the remote control.
The settings may be selected between the following two: Function Number or Setting Value.
Settings will not be changed if invalid numbers or setting values are selected.
1-1. Setting the Cooler Room Temperature Correction
Depending on the installed environment, the room temperature sensor may require a correction.
The settings may be selected as shown in the table below.
Setting Description
Standard
Lower control
1-2. Setting the Heater Room Temperature Correction
Depending on the installed environment, the room temperature sensor may require a correction.
The settings may be changed as shown in the table below.
Setting Description
Standard
Lower control
Slightly warmer control
Warmer control
1-3. Setting Other Functions
The following settings are also possible, depending on the operating conditions.
Auto Restart
Setting Description
Yes
No
(
Function Number Setting Value
30
(
Function Number Setting Value
31
(
Function Number
40
08-01
Factory setting)
00
01
Factory setting)
00
01
02
03
Factory setting)
Setting Value
00
01