Toyota 2006 Rav4 Owner's Manual page 162

To activate the system, push the "AUTO
LSD" switch with the vehicle stopped.
The "AUTO LSD" indicator light will come
on and remain on while the system is on.
While the system is operating, the slip
indicator light will also flash.
To cancel the system, push the "AUTO
LSD" switch once again and the "AUTO
LSD" indicator light will go off.
If the vehicle speed exceeds 50 km/h (31
mph), this system will be cancelled auto-
matically.
152
'06 Rav4_U (L/O 0601)
The "AUTO LSD" indicator light will come
on for a few seconds when the ignition
key is turned to "ON". If the indicator light
does not come on when the ignition key
is turned to "ON" or the "AUTO LSD"
switch is pushed, contact your Toyota
dealer.
If the brake actuator temperature becomes
too high, a buzzer will sound for about 3
seconds. (The slip indicator light will also
be lit.) The system will temporarily stop
operating in order to protect the brake
actuator. Although "AUTO LSD" system is
not operating, it is still possible to contin-
ue your driving.
The operation of the system will be auto-
matically restored after the actuator cools
down. After operation is restored, the slip
indicator light will go off.
"VSC" warning light
This light warns that there is a problem
somewhere in the following systems:
Traction control system
D
"AUTO LSD" system
D
Vehicle stability control system
D
Downhill assist control system
D
Hill- start assist control system
D
When the ignition key is turned to "ON",
the light will come on. When the systems
are work properly, the light turns off after
a few seconds.
2005 RAV4 from Jan. '06 Prod. (OM42620U)