Stanley PS161-6 Installation Instructions Manual page 6

Figure 5
Door
Green
Wire
Strap
(ground)
(from
Enclosure
to Door)
CAUTION: When power supply board is set for 12VDC use only one (1) 12VDC stand-by battery.
Keep power-limited wiring separate from non power-limited. Use minimum 0.25" spacing.
7AH Rechargeable batteries are the largest batteries that can fit in this enclosure.
Lead
L 120VAC
power mains
G
Non Power-
limited
AC1
NC
Battery & AC
C
Supervision
NO
Circuit
NC
(Power-limited)
C
NO
AC
DC
AC DELAY
SHUTDOWN
Battery
Power-
Connections
limited
(Non
Power-limited)
--- BAT +
Optional Rechargeable Stand-by
Battery for UL294 Applications.
Note: 12V batteries required for UL603,
UL1481 and Canadian installations.
Switch Detail
OPEN 24V
CLOSED 12V
OPEN --- 24V
CLOSED --- 12V
--- DC +
6/9
Edge of
Enclosure
Enclosure
to Access Control
Sentrol
Panel or
model # 3012
U.L. Listed
Tamper Switch
Reporting
or equivalent
Device
(Not Included)
PD8UL/PD8ULCB PD16W/
PD16WCB
DC Output to devices*
(refer to Fig. 3a, 3b, 4a or 4b
for board configuration pg. 6)
Optional Rechargeable Stand-by
Battery for UL294 Applications.
Note: 12V batteries required for UL603,
UL1481 and Canadian installations.
02140-11-E Copyright Stanley Security, Inc. 2014
©