Installation For Mac; Installing The Ucg102; Installing The Guitar Combos Software - Behringer LINK UCG102 Installation Manual

14 GUITAR LINK UCG102 Software Installation Guide
Clicks or dropouts in recording
1) Start the ASIO-USB Control Panel from within the audio software
(may be called ASIO Config or similar).
2) USB Device = BEHRINGER USB AUDIO.
3) Click on the ASIO tab.
System Performance = normal.
4)
Visit musicXP.net for some helpful advice about optimizing
Windows XP for music applications.

3. Installation for Mac

3.1 Installing the UCG102

To setup the UCG102, proceed as follows:
1) Power on your computer.
2) Connect the UCG102 with the USB cable to your Mac.
3.2 Installing the guitar combos software
The Guitar Combos software consists of three different combos.
Choose any or all of them for installation. With the serial number on
the CD sleeve you can fully activate one combo. The other combos can
be run in demo mode with the following restrictions:
•
Saving of sounds is disabled
•
Quits after 30 minutes
•
Total recall is disabled
To install a combo on your system,
proceed as follows:
1) From the folder "NI Guitar Combos" on your CD, choose the
combo you wish to install and open the respective archive file
(ZIP) by double-clicking on its entry.
2) Double-click on the installer icon on the desktop, to start
the installation.
3) Follow the on-screen instructions.
If you have the serial number for the installed combo:
4) Accept to start the NI Service Center, upon request.
◊
If your computer is not connected to the internet, choose the
offline registration method to activate the combo via
another computer.