Hitachi 46UX51K Service Manual page 17

Perform the following when the
I-IV connector (anode connector)
is removed or inserted for CPT
replacement, etc.
Anode
connector
Deflection P.W.B. '
FBT
Roll out silicon cover from FBT's contact area slowly.
the connector about 90 degrees
following the arrow (0 position), push the connector
slightly towards the case. (Fig. A)
Fig. A
Silicon cover
3.
Remove the connector slowly
by pulling it away from the
case.
Wing
L Position
L Position
Fig. 6
During Insertion
1. Please refer to direction for insertion as shown in Fig. B (L position). Insert connector until "CLICK' sound is heard.
2. Make sure the connector is pressed right in, so that it has a good contact with the spring.
3. Confirm the contact by pulling the connector slightly. (Don't pull hard because it may damage the connector).
4. Cover the high voltage output by carefully pushing silicon cover onto it. (Don't turn the connector).
(REMARK)
1.
Make sure the silicon cover is
A
/ Silicon Cover
I
covering the high voltage output.
less than lmm
17