Norcold NX64 Installation Manual page 14

Hide thumbs Also See for NX64:
Table of Contents

Advertisement

Available languages

Available languages

- Turn each bent hinge over and attach it, with the screws, to the
opposite side of the other door.
- If you removed the bent hinge [275a] from the left side of
upper door, attach the bent hinge [275b] to the right side of
the lower door.
- If you removed the bent hinge from the right side of upper
door, attach the bent hinge to the left side of the lower door.
- With the handle latches and springs in place, turn each door
handle over and attach it, with the screws, to the opposite side
of the other door.
- Make sure that the latch and the spring are in each door
handle.
- If you removed the door handle [70a] from the left side of
upper door, attach the door handle [70b] to the right side of
the lower door.
- If you removed the door handle from the right side of upper
door, attach the door handle to the left side of the lower
door.
- Put a hinge bushing back into each door hinge.
4. Reinstall the doors:
- Turn the lower (straight) hinge pin [64] into each of the lower
cabinet hinges (See Art02389).
To prevent damage to the threads of the hinge
NOTICE
pins, turn the hinge pins by hand until tight
and then tighten with a 7/16 inch wrench or a
screwdriver.
Apply Loctite removable thread locker
!
(blue) to the threads of the hinge screws
CAUTION
before assembly to prevent loosening
during use. Do not allow Loctite to contact
any of the plastic surfaces of the refrigerator
because it can damage those surfaces.
- Put each door down onto the lower hinge pin.
- Align the holes in the upper hinges and hold in this position.
- Turn the upper hinge pin [63] into the hinges of each door (See Art02387).
- Put the storage bins in the doors.
- Close the doors
- Tighten the hinge pins.
5. Reinstall the control cover:
- Using screws, attach the control cover [270] to the refrigerator.
- Carefully push the snap-on control façade [271] onto the control cover (See Ar02386).
- You may hear a "click' sound or feel a "snap" in your fingers when the control façade fully engages into the control cover.
Installation Manual 14
274b
70a
275b
274b
74
274a
275a
74
70b
274a
74
Art02391

Advertisement

Table of Contents
loading

This manual is also suitable for:

Nx84imNx64imNx84

Table of Contents