Assembly And Set-Up; Charging The Battery - Razor E90 Owner's Manual

ASSEMBLY AND SET -UP
q Attaching the Handlebars
Tools Required: 5 mm Allen wrench
1
Loosen the collar clamp.
With a clock-wise twisting
motion, push and "thread" the
handlebar stem into the fork
until it bottoms out on the fork
headset lock nut.

CHARGING THE BATTERY

q Charging the Battery
Your electric scooter may not have a fully charged battery; therefore you must charge the battery prior to use.
• Initial charge time: 12 hours.
• Recharge time: up to 12 hours, even if the light
turns green. Recommended maximum charging time
is 24 hours.
• Always charge the battery immediately after riding.
• Fully charge battery before storing for extended
periods of time.
• Unplug charger from the wall outlet when not in use.
• Failure to recharge battery periodically may result in a
battery that will not accept a charge.
Charger
Note: Make sure power is turned
OFF when unit is not in use. If
the power switch is left on for
an extended period of time, the
battery may reach a stage at which
it will no longer hold a charge.
2
With the front wheel pointed
straight ahead and the handlebars
square to the front wheel, tighten
the clamp as shown with a 5 mm
Allen wrench. Tighten securely.
• Make sure the power switch is turned OFF when
unit is not in use. If the power switch is left on for an
extended period of time, the battery may reach a stage
at which it will no longer hold a charge.
• To ensure long battery life, never store the product in
freezing or below freezing temperatures! Freezing will
permanently damage the battery.
• Run time: Up to 40 minutes of continuous ride time.
Run time may vary depending on riding conditions,
rider weight, climate, and/or proper maintenance.
• Battery life can vary depending on proper maintenance
and usage of the unit.
1
Plug the charger into a wall outlet.
If the lights on charger do not light
up, check the power to the outlet. If
necessary, try a different outlet.
2
Turn power OFF before charging.
Plug the charger into the charger
port on the electric scooter.
3
Note:
Make sure any cables/wires
are out of the way before inserting
the stem into the fork.
WARNING: Failure to
properly tighten the collar clamp
may allow the handlebars to
dislodge while riding and may cause
you to lose control and fall. When
correctly tightened, the handlebars
will not rotate out of alignment
with the front wheel under normal
circumstances.
WARNING: Use ONLY with
the recommended charger. Batteries
are only to be charged under
adult supervision. The charger is
not a toy. Always disconnect the
charger before wiping down and/or
cleaning the electric scooter with a
damp cloth.
The charger supplied with the
electric scooter should be regularly
examined for damage to the cord,
plug, enclosure and other parts.
In the event of such damage,
the electric scooter must not be
charged until it has been repaired
or replaced.
Chargers have built-in overcharge
protection to prevent battery from
being overcharged.
Note: If the charger gets warm
during regular use, this is a normal
response and is no cause for
concern. If your charger does not
get warm during use, it does not
mean that it is not working properly.
Wall outlet - Green
Wall outlet and Unit - Red (charging)
Charging complete - Green
Note: Continue charging unit even
if light turns green prior to 12 hours.
WARNING: Failure to
recharge the battery at least once a
month may result in a battery that
will no longer accept a charge.