AT&T 1825 User Manual

At&t user manual deluxe tapeless digital answering system 1825

Advertisement

1
USER'S MANUAL
Part 2
Deluxe Tapeless Digital
Answering System with
Four Mailboxes and
Speakerphone 1825
Fold open this manual for information about this
product's installation and operation. Please
also read Part 1 – Important Product Information.
AT&T and the globe symbol are registered trademarks of AT&T Corp. licensed to Advanced American Telephones.
© 2000 Advanced American Telephones. All rights reserved.
Printed in Mexico. 850002775 Issue 1AT&T 5/00

Advertisement

Table of Contents
loading

Summary of Contents for AT&T 1825

  • Page 1 Part 2 Deluxe Tapeless Digital Answering System with Four Mailboxes and Speakerphone 1825 Fold open this manual for information about this product’s installation and operation. Please also read Part 1 – Important Product Information. AT&T and the globe symbol are registered trademarks of AT&T Corp. licensed to Advanced American Telephones.
  • Page 2: Installation

    I N S T A L L A T I O N RING SELECT ANNC SELECT MSG ALERT POWER For Table/Desk Installation Install the batteries. • Turn the unit upside down. • Push in on the two tabs at the large end of the base, and lift the base off the unit.
  • Page 3 I N S T A L L A T I O N PULL TABS TO OPEN Figure 1 For Wall Installation Reverse the handset tab. (This tab holds the handset when you hang up.) Hold down the switchhook, and slide the tab up and out of its slot.
  • Page 4 C A S E If this telephone does not work properly, try the following suggestions. If you’re still having difficulty, call 1 800 222–3111. No Dial Tone • Make sure all plugs are connected properly. Check the line cord connections at the wall jack and at the telephone.
  • Page 5: Operation

    T E L E P H O N E Making/Answering Calls Lift the handset or press K. To end a call, hang up or press K. To switch from handset to speakerphone, press K, then hang up. To switch from speakerphone to handset, lift the handset.
  • Page 6: Storing Memory Numbers

    T E L E P H O N E Light is on when phone line is in use Store a pause in a memory dial number Dial numbers in telephone memory Store numbers in telephone memory Temporary Tone Microphone The telephone can store nine telephone numbers, each up to 24 digits long.
  • Page 7: Answering System Operation

    A N S W E R I N G S Y S T E M O P E R A T I O N Set and hear time/day Set and hear Remote Access and Priority Calling Codes Use with other buttons to change settings Record and hear outgoing announcement...
  • Page 8: Volume Control

    A N S W E R I N G S Y S T E M O P E R A T I O N You can record up to three different announcements — A, B, and AO. Announcements A and B are used when you want the system to record callers’...
  • Page 9: Listening To Your Messages

    A N S W E R I N G S Y S T E M O P E R A T I O N Listening to Your Messages As the system plays back messages in a mailbox, the Message Window displays the number of the message playing.
  • Page 10: Recording A Memo

    A N S W E R I N G S Y S T E M O P E R A T I O N Recording a Memo You can record a memo to be stored as an incoming message. The memo can be up to three minutes long, and will be played back with other messages.
  • Page 11: Room Monitor With Intercom

    R E M O T E Remote Access Code You can use many features of this answering system remotely from a touch tone phone. Most features can be accessed only after you enter a Remote Access Code, preset to 500. You can view the Remote Access Code by tapping Connect with the Answering System Dial your telephone number from a touch tone phone.
  • Page 12: Memory Full

    R E M O T E Changing Your Remote Access Code Connect with the answering system. Press and release 9, 9. The system announces “Enter new code.” Enter your new Remote Access Code (any number between 500 and 999 except for the Priority Calling Code).
  • Page 13 Telephones. American fold Tapeless Digital Answering System 1825 Remote Commands To connect with your answering system: Dial your telephone number from a touch tone phone. When the system answers, enter your Remote Access Code. The system announces the number of messages and beeps twice.
  • Page 14 COMMAND PRESS 1, then enter mailbox Play all messages in a mailbox number 2, then enter mailbox Play only new messages in a mailbox number 4 while message is Repeat message playing 6 while message is Skip message playing 3, then enter mailbox Delete all messages in a mailbox number 3 while message is...

Table of Contents