When Replacing Eeprom (Memory) Ic - Toshiba VTV1400 Service Manual

Color television/ video cassette recorder

Table of Contents

If a service repair is undertaken where it has been required to change the MEMORY IC, the following steps should be taken to

ensure correct data settings while making reference to TABLE 1.

NOTE: Initial Data setting will not be possible if clock has been set. To reset clock, either unplug AC cord and allow

at least 30 minutes before Power On or alternatively, discharge backup capacitor.

INI

0B0

---

0C0

0D0

0E0

0F0

100

110

120

130

140

150

Enter DATA SET mode by setting VOLUME to minimum.

While holding down VOLUME button on front cabinet, press key 6 on remote control for more than 2 seconds.

ADDRESS and DATA should appear as FIG 1.

ADDRESS is now selected and should "blink". Using the PLAY or STOP button on the remote, step through the

ADDRESS until required ADDRESS to be changed is reached.

Press ENTER to select DATA. When DATA is selected, it will "blink".

Again, step through the DATA using PLAY or STOP button until required DATA value has been selected.

Pressing ENTER will take you back to ADDRESS for further selection if necessary.

Repeat steps 3 to 6 until all data has been checked.

When satisfied correct DATA has been entered, turn POWER off (return to STANDBY MODE) to finish DATA input.

The unit will now have the correct DATA for the new MEMORY IC.