Metabo SB 710 Original Instructions Manual page 13

17026969_0610 SB_Bauk10.book Seite 13 Freitag, 18. Juni 2010 9:42 09
8.2 Setting direction of rotation, transport
lock (switch-on lock)
(except SB 710)
Do not activate the rotation selector switch
(11) unless the motor has completely
stopped.
See page 3 (please unfold).
R = Clockwise setting
L = Counter-clockwise setting
0 = Central position: transport lock setting
(switch-on lock)
8.3 Setting up drilling, impact drilling
Press the slide switch (7).
= Impact drilling
= Normal drilling without impact
Note: Impact drilling and drilling, only in clock-
wise direction
Note: When impact drilling, use a high speed:
Select 2nd gear on thumbwheel (1).
8.4 Selecting a gear
Select the desired gear by turning the thumbwheel
(1).
Change speed only when the machine is in the
process of running down (briefly switch it on and
off).
1st gear (low speed, high torque) e.g. for
screwdriving, drilling
2nd gear (high speed) e.g. for drilling, impact
drilling
8.5 Preselect speed
(except SB 710)
Use the setting wheel (8) to preselect the
maximum speed. See page 4 for recommended
drilling speeds.
8.6 Setting up torque control
(SBE 900 Impuls)
Set using setting wheel (9) (position 1 - 6). When
the preselected torque is reached, the motor
stops.
1 = When a low torque is reached, the motor
stops.
6 = When a high torque is reached, the motor
stops.
+ = Drill setting - not torque control (for max.
torque)
8.7 Switching on impulse function
(SBE 900 Impuls)
Set using setting wheel (9).
= Impulse function always switched on
+ = Impulse function off (for drilling)
8.8 Switching on/off, changing speed
Switching on, speed: press the trigger (13).
The speed can be changed by pressing in the
trigger.
The electronic soft start means that the
machine accelerates continuously until the
preselected speed is reached (depends on
equipment).
Release the trigger to switch off.
Continuous activation: While pressing on the
trigger (13), press in the locking button (12) and
then release the trigger. To switch off, press
and release the trigger (13) again.
In continuous operation, the machine
continues running if it is forced out of
your hands. Therefore, always hold the
machine with both hands using the handles
provided, stand in a safe position and concen-
trate.
8.9 Tool change with Futuro Top keyless
chuck (6)
See illustrations A on page 3.
Opening the chuck: Grip the retaining ring and,
using the other hand, rotate the sleeve in the direc-
tion of the arrow -1-.
Clamping the tool: Insert tool -2- as far as it will
go. Grip the retaining ring and, using the other
hand, firmly rotate the sleeve as far as it will go in
the direction of the arrow -3-.
8.10 Tool change with Plus (5) chuck
See illustrations B on page 3.
Opening the drill chuck:
Grip the retaining ring and, using the other hand,
rotate the sleeve in the direction of the arrow -1-.
The grating sound (depending on function) which
may be heard after opening the drill chuck is
ENGLISH
ENG
13