1. DISASSEMBLY
• This set can be disassembled in the order shown below.
Front panel section
Rotary motor ass'y
(M951) (Page 2-2)
2. NOTE ON REMOVE THE CASE
1) Remove seven tapping screws. (See Fig. 1)
2) Open the side of case. (See Fig. 1)
3) Remove the case as lift straight. (See Fig. 1)
Case
Two tapping screws
SERVICE NOTE
Set
Case
(Page 2-1)
Rear panel section
(Page 2-1)
(Page 2-2)
Table ass'y
(Page 2-2)
Chassis ass'y
(Page 2-2)
Loading motor ass'y
(M991) (Page 2-3)
Three tapping screws
Two tapping screws
Fig. 1
MB-85 board
(Page 2-1)
BU holder ass'y
(Page 2-3)
TK-53 board
(Page 2-3)
3. DISC REMOVAL PROCEDURE
(at POWER OFF)
1) Insert a flat-blade screwdriver into a hole at the bottom, and
rotare the cam gear in direction A. (See Fig. 2)
Table
– 4 –
AU-215 board
(Page 2-1)
Optical pick-up
(Page 2-3)
Cam gear
Hole
A
Fig. 2