Installing The Battery; Charging The Battery; Turning Your Phone On; Adjusting Volume - Motorola V975 User Manual

Installing the Battery

Your phone is designed to use only Motorola Original™
batteries and accessories.
1
3
16 - Getting Started
Action
4 If necessary, enter your SIM card PIN code and press the
key to unlock the SIM card.
Caution: If you enter an incorrect PIN code 3 times in a row,
your SIM card is disabled and your phone displays
5 If necessary, enter your four-digit unlock code and press
key to unlock the phone.
Tip: The unlock code is originally set to 1234. Your service
provider may change this number before you receive your
phone.

Adjusting Volume

Press the up or down volume keys
to:
• increase or decrease earpiece
volume during a call
• increase or decrease speakerphone volume during a call
• turn off an incoming call alert
• increase or decrease the ringer volume setting when the home
screen is visible
Tip: At the lowest volume setting, press the down volume key
once to switch to vibrate alert. Press it again to switch to silent
alert. Press the up volume key to cycle back to vibrate alert,
then ring alert.
18 - Getting Started
2
OK
SIM Blocked
OK

Charging the Battery

New batteries are shipped partially charged. Before you can use
your phone, you need to install and charge the battery as described
below. Some batteries perform best after several full charge/
discharge cycles.
Action
1 Plug the travel charger into
your phone with the release
tab facing up.
2 Plug the other end of the travel charger into the appropriate
electrical outlet.
3 When your phone indicates
tab and remove the travel charger.
Tip: You can safely leave the travel charger connected to your
phone after charging is complete. This will not damage the battery.

Turning Your Phone On

Action
1 Open your phone.
2 Press and hold o for
2 seconds to turn on the
phone.
3 If necessary, press S to scroll to the User Account you
want. Then press the
list (stored on the SIM card).

Making a Call

To make video calls, see page 21.
Press
1 keypad keys
.
2 n
3 o
Tip: You can also close the phone to end the call.
Note: You can make an emergency call even when the phone is
locked, or when a SIM card is not inserted (see page 62).

Answering a Call

When you receive a call, your phone rings and/or vibrates and
displays an incoming call message.
When
Open to Answer
Open to Answer
>
Open to Answer
If
Open to Answer
Press
1 n
or
DIVERT
2 o
Charge Complete
key to select the account from the
SELECT
To
dial the phone number
make the call
end the call and "hang up" the phone
when you are finished
is , open the phone to answer the call. To set
On
, press M > >
Settings In-Call Setup
.
is :
Off
To
answer the call
or o divert the call to your voicemail or call
divert number, as though your line was
busy
end the call and "hang up" the phone when
you are finished
, press the release
Getting Started - 17
>
Answer Options
Getting Started - 19