Remote Control
Install the batteries
Use batteries type UM3 (AA-Size).
Do not use old or weak batteries. The remote control may not work properly with a weak voltage from such
batteries. Replace exhausted batteries with new ones. Never try to recharge normal batteries - this could
cause an explosion.
Note:
Exhausted batteries can leak corrosive electrolyte, which may cause damage to the remote control -
therefore remove exhausted batteries immediately.
1
Open the battery
compartment.
Distance of Remote Control Operation
The remote control handset will not work properly in the following cases:
If bright sunlight directly beams onto the unit front.
If the batteries have not been installed according to
their polarities.
8
32L0141B_Eng.indd 8
32L0141B_Eng.indd 8
2
Install the batteries as shown
below, ensuring the correct
polarity.
Point the remote control
directly at the remote sensor.
3
Close the battery
compartment.
Remote sensor
Maximum distance approx. 5m
30
30
Transmitter window
If an obstacle is placed between the unit and the
handset.
If the batteries are weak.
6/7/2007 9:21:12 AM
6/7/2007 9:21:12 AM