Panasonic FZ-G1 Series Operating Instructions Manual page 34

Troubleshooting (Basic)
n Starting Up
Cannot resume.
Other startup problems.
n Entering Password
Even after entering the
password, password in-
put screen is displayed
again.
34
l One of the following operations may have been carried out. Press the
power switch to turn on the computer. Data not saved will be lost.
Ÿ In sleep mode, the AC adaptor or battery pack was disconnected, or
a peripheral was connected or disconnected.
Ÿ The power switch was pressed for four seconds or longer to forcibly
turn off the computer.
l An error may occur when the computer automatically enters the sleep
or hibernation mode while the screensaver is active. In this case, turn
off the screensaver or change the pattern of the screensaver.
l Start the Setup Utility (è
turn the Setup Utility settings (excluding the passwords) to the default
values. Start the Setup Utility and make the settings again.
l Remove all peripheral devices.
l Check to see if there was a disk error.
A Remove all peripheral devices including an external display.
B Open "Computer".
1. On the Start screen, flick from bottom side to inside of the
screen.
2. Touch [All apps] on the toolbar.
3. Touch [Computer] under "Windows System".
Touch (Start) - [Computer].
C Long touch [Local Disk (C:)], and touch [Properties].
D Touch [Tools] - [Check Now...].
Ÿ A standard user needs to enter an administrator password.
E Select the option in [Check disk options] and touch [Start].
F Touch [Schedule disk check] and restart the computer.
l
Connect the external keyboard and start the computer in Safe Mode,
then check the error details. When the [Panasonic] boot screen dis-
*1
appears at startup, press and hold
Options Menu is displayed. Select the Safe Mode and press
*1
When [Password on boot] is set to [Enabled] in the [Security] menu
of the Setup Utility, [Enter Password] appears after the [Panasonic]
boot screen disappears. As soon as you enter the password and press
Enter
, press and hold
<Only if the external keyboard is connected>
l The computer may be in ten-key mode.
If the NumLk indicator
key mode, and then input.
l The computer may be in Caps Lock mode.
If the Caps Lock indicator
Caps Lock mode, and then input.
Reference Manual "Setup Utility") to re-
F8
until the Windows Advanced
F8
.
NumLk
lights, press
Caps Lock
lights, press
Enter
.
to disable the ten-
to disable the